BIRC3 Kit ELISA

N° du produit ABIN625459

Détail du produit BIRC3 Kit ELISA

Antigène: BIRC3 (Baculoviral IAP Repeat Containing 3 (BIRC3))

Reactivité: Humain

Méthode de détection: Colorimetric

Type de méthode: Sandwich ELISA

Gamme de detection: 1-250 ng/mL

Seuil minimal de détection: 1 ng/mL

Application: ELISA

Fonction: Human cIAP-2 ELISA Kit for cell culture supernatants, plasma, and serum samples.

Type d'échantillon: Plasma, Cell Culture Supernatant, Serum

Analytical Method: Quantitative

Specificité: This ELISA antibody pair recognizes human CIAP-2. Other species not determined yet.

Sensibilité: < 1 ng/mL

Attributs du produit:

• Strip plates and additional reagents allow for use in multiple experiments
• Quantitative protein detection
• Establishes normal range
• The best products for confirmation of antibody array data

Ingrédients:

• Pre-Coated 96-well Strip Microplate
• Wash Buffer
• Stop Solution
• Assay Diluent(s)
• Lyophilized Standard
• Biotinylated Detection Antibody
• Streptavidin-Conjugated HRP
• TMB One-Step Substrate

Matériel non inclus:

• Distilled or deionized water
• Precision pipettes to deliver 2 μL to 1 μL volumes
• Adjustable 1-25 μL pipettes for reagent preparation
• 100 μL and 1 liter graduated cylinders
• Tubes to prepare standard and sample dilutions
• Absorbent paper
• Microplate reader capable of measuring absorbance at 450nm
• Log-log graph paper or computer and software for ELISA data analysis

Information d'application

Indications d'application: Recommended Dilution for serum and plasma samples2 - 10 fold

Volume d'échantillon: 100 μL

Plaque: Pre-coated

Protocole:

1. Prepare all reagents, samples and standards as instructed in the manual.
2. Add 100 μL of standard or sample to each well.
3. Incubate 2.5 h at RT or O/N at 4 °C.
4. Add 100 μL of prepared biotin antibody to each well.
5. Incubate 1 h at RT.
6. Add 100 μL of prepared Streptavidin solution to each well.
7. Incubate 45 min at RT.
8. Add 100 μL of TMB One-Step Substrate Reagent to each well.
9. Incubate 30 min at RT.
10. Add 50 μL of Stop Solution to each well.
11. Read at 450 nm immediately.

Préparation des réactifs:

1. Bring all reagents and samples to room temperature (18 - 25 °C) before use.
   2. Sample dilution: If your samples need to be diluted, 1x Assay Diluent D (Item K) should be used for dilution of serum/plasma /culture supernatants/urine. Suggested dilution for normal serum/plasma: 2-10 fold. Please note that levels of the target protein may vary between different specimens. Optimal dilution factors for each sample must be determined by the investigator.
   3. Assay Diluent D (Item K) and Assay Diluent B (Item E) should be diluted 5-fold with deionized or distilled water before use.
   4. Preparation of standard: Briefly spin the vial of Item C. Add 640 µL 1x Assay Diluent D (Item K, Assay Diluent D should be diluted 5-fold with deionized or distilled water before use) into Item C vial to prepare a 250 ng/mL standard solution. Dissolve the powder thoroughly by a gentle mix. Pipette 300 µL 1x Assay Diluent D into each tube. Use the 250 ng/mL standard solution to produce a dilution series . Mix each tube thoroughly before the next transfer. 1x Assay Diluent D serves as the zero standard (0 ng/mL). 200 µL 200 µL 200 µL 200 µL 200 µL Standard, Item C + 640 µL 200myl 250 100 40 16 6.4 2.56 1.02 0 ng/mL ng/mL ng/mL ng/mL ng/mL ng/mL ng/mL ng/mL
   5. If the Wash Concentrate (20x) (Item B) contains visible crystals, warm to room temperature and mix gently until dissolved. Dilute 20 ml of Wash Buffer Concentrate into deionized or distilled water to yield 400 ml of 1x Wash Buffer.
   6. Briefly spin the Detection Antibody vial (Item F) before use. Add 100 µL of 1x Assay Diluent B (Item E) into the vial to prepare a detection antibody concentrate. Pipette up and down to mix gently (the concentrate can be stored at 4 °C for 5 days). The detection antibody concentrate should be diluted 80-fold with 1x Assay Diluent Buffer used in step 4 of Part VI Assay Procedure.
   7. Briefly spin the HRP-Streptavidin concentrate vial (Item G) and pipette up and down to mix gently before use. HRP-Streptavidin concentrate should be diluted 600-fold with 1x Assay Diluent B (Item E). For example: Briefly spin the vial (Item G) and pipette up and down to mix gently . Add 20 µL of HRP-Streptavidin concentrate into a tube with 12 ml 1x Assay Diluent B to prepare a 600-fold diluted HRP-Streptavidin solution (don't store the diluted solution for next day use). Mix well.

Procédure de l'essai:

1. Bring all reagents and samples to room temperature (18 - 25 °C) before use. It is recommended that all standards and samples be run at least in duplicate.
   2. Add 100 µL of each standard (see Reagent Preparation step 2) and sample into appropriate wells. Cover well and incubate for 2.5 hours at room temperature or over night at 4 °C with gentle shaking.
   3. Discard the solution and wash 4 times with 1x Wash Solution. Wash by filling each well with Wash Buffer (300 myl) using a multi-channel pipette or autowasher. Complete removal of liquid at each step is essential to good performance. After the last wash, remove any remaining Wash Buffer by aspirating or decanting. Invert the plate and blot it against clean paper towels.
   4. Add 100 µL of 1x prepared biotinylated antibody (Reagent Preparation step 6) to each well. Incubate for 1 hour at room temperature with gentle shaking.
   5. Discard the solution. Repeat the wash as in step
   6. Add 100 µL of prepared Streptavidin solution (see Reagent Preparation step 7) to each well. Incubate for 45 minutes at room temperature with gentle shaking.
   7. Discard the solution. Repeat the wash as in step
   8. Add 100 µL of TMB One-Step Substrate Reagent (Item H) to each well. Incubate for 30 minutes at room temperature in the dark with gentle shaking.
   9. Add 50 µL of Stop Solution (Item I) to each well. Read at 450 nm immediately.

Calcul des résultats:

Calculate the mean absorbance for each set of duplicate standards, controls and samples, and subtract the average zero standard optical density. Plot the standard curve on log-log graph paper or using Sigma plot software, with standard concentration on the x-axis and absorbance on the y-axis. Draw the best-fit straight line through the standard points.
Typical Data: These standard curves are for demonstration only. A standard curve must be run with each assay. 1xAssay Diluent D Human CIAP-2 concentration (ng/mL) 0.1 1 10 100 1000 O D =4 50 n m 0.01 0.1 1 10
Sensitivity: The minimum detectable dose of cIAP-2 is typically less than 1 ng/mL.
Recovery: Recovery was determined by spiking various levels of cIAP-2 into normal human serum, plasma and cell culture media. Mean recoveries are as follows: Sample Type Average % Recovery Range ( %) Serum 89.48 81-98 Plasma 82.86 76-89 Cell culture media 91.70 78-103
Linearity: Sample Type Serum Plasma Cell Culture Media 1:2 Average % of Expected 123.6 128.7 134.5 Range ( %) 116-132 121-137 127-113 1:4 Average % of Expected 126.9 138.5 142.8 Range ( %) 119-137 125-145 137-148
Reproducibility: Intra-Assay: CV<10 % Inter-Assay: CV<12 %

Précision du teste: Intra-Assay: CV< 10 % Inter-Assay: CV< 12 %

Restrictions: For Research Use only

Stockage

Conseil sur la manipulation: Avoid repeated freeze-thaw cycles.

Stock: -20 °C

Stockage commentaire: The entire kit may be stored at -20°C for up to 1 year from the date of shipment. Avoid repeated freeze-thaw cycles. The kit may be stored at 4°C for up to 6 months. For extended storage, it is recommended to store at -80°C.

Date de péremption: 6 months

Détail du antigène

Antigène: BIRC3 (Baculoviral IAP Repeat Containing 3 (BIRC3))

Autre désignation: CIAP-2 (BIRC3 Produits)

Synonymes: AIP1 Kit ELISA, API2 Kit ELISA, CIAP2 Kit ELISA, HAIP1 Kit ELISA, HIAP1 Kit ELISA, MALT2 Kit ELISA, MIHC Kit ELISA, RNF49 Kit ELISA, c-IAP2 Kit ELISA, Api1 Kit ELISA, Api2 Kit ELISA, IAP1 Kit ELISA, IAP2 Kit ELISA, MIHB Kit ELISA, Birc2 Kit ELISA, HIAP2 Kit ELISA, MIAP1 Kit ELISA, MIAP2 Kit ELISA, cIAP1 Kit ELISA, cIAP2 Kit ELISA, cIAP-1 Kit ELISA, cIAP-2 Kit ELISA, AW107670 Kit ELISA, BIRC2 Kit ELISA, baculoviral IAP repeat containing 3 Kit ELISA, baculoviral IAP repeat-containing 3 Kit ELISA, baculoviral IAP repeat-containing protein 3 Kit ELISA, inhibitor of apoptosis protein-2 Kit ELISA, BIRC3 Kit ELISA, Birc3 Kit ELISA, LOC100399118 Kit ELISA, OpmnVgp074 Kit ELISA

ID gène: 330

UniProt: Q13489

Pathways: Apoptose, Caspase Cascade in Apoptosis, Activation of Innate immune Response, Toll-Like Receptors Cascades